StoreTender Online  Version 8  ©2015,  Aloha Data Systems, Inc.

Avery-Berkel 6720 Scale Programming

 

          Steps to work with StoreTender Online

 

Remove any weight from the scale before starting.

 

1. Turn the power off and remove the platter.

2. Remove the plate covering the dip switches.

3. Set dip switch 1 to the OFF position. Switches 2, 3 and 4 should be in the ON position.

4. Power the unit on. The scale should display “DIAG

5. Press the [ZERO] once. The scale should display “CONFIG

6. Press the [TEST] once. The scale should display “FILT

7. Press the [ZERO] once. The scale should display “BAUD

8. Press the [TEST] once. The scale will display the current baud rate selection.

9. Press the [ZERO] until the scale displays “96 E” if it doesn’t already.

10. Press the [TEST] once. The scale should display BAUD

11. Press the [ZERO] once. The scale displays “PROT

12. Press the [TEST] once. The scale will display the current protocol selection.

13. Press the [ZERO] until the scale displays “NCI” if it doesn’t already.

14. Press the [TEST] once. The scale displays “PROT

15. Press the [ZERO] once. The scale displays “DONE

16. Press the [TEST] to save settings.

17. Turn off the power

18. Set all dip switches to the ON position and replace the cover.

19. Turn on the power to the scale.

 

The scale should display 0.00 lb 

 

A standard 9 pin male to female serial cable is required. A NULL modem cable WILL NOT work!

 

StoreTender is expecting the scale to be set to 9600, e, 7, 1 (factory default)

 

StoreTender will NOT work properly if the above steps are not followed exactly!